A Review on Experimental investigation and Analysis of cooling tower to enhance its efficiency by fin geometry
Keywords:
fin, fills, heat exchanger, mechanical draftAbstract
A cooling tower is an essential component of power plants, petrochemical plants, oil treatment facilities, semi-conductor plants, petroleum gas preparing plants, nourishment handling plants, and so on. The significant capacity of a cooling tower is to discard of heat into the environment. The significant sorts of cooling towers are the mechanical draft (incited draft) and normal draft cooling towers. Tubes having (fins) blades for increment surface zone of tube. Mechanical draft cooling towers utilize huge fans to suck or power air through coursed water overload. The cascades downhill over the fill media, which expands the contact time between the air and the water, this augments heat move between them. The counter-stream and cross streams are two basic structures of incited (mechanical) cooling tower. It is notable that heat flow in counter stream is more compelling than heat flows in cross-stream or parallel stream. This paper is all about the developing a cooling tower that cools the hot water by using different types of tubes of same material. Tubes having different surface area that helps the heat dissipation. Tubes having fins for increase surface area of tubes.
References
M. M. Patil, S. J. Patil, P. S. Patil, and S. J. Mehta, “Design and Analysis of Cooling Tower,”, pp. 05–11, 2018.
A. Ayoub, G. Sansavini, and G. Sansavini, “Accepted Manuscript,”, pp. 15–17, 2018.
J. Lee, “Evaluation of impacts of cooling tower design properties on the near- field environment,” Nucl. Eng. Des., vol. 326, no. April 2017, pp. 65–78, 2018.
W. Wang, H. Zhang, Q. Liu, G. Yue, and W. Ni, “Energy & Buildings , A performance enhancement of a natural draft dry cooling tower in cross wind via inlet flow field reconstruction,” Energy Build., vol. 164, pp. 121–130, 2018.
M. Goodarzi and S. M. Maryamnegari, “A new natural draft dry cooling tower with improved thermal performance during windy condition,” Appl. Therm. Eng., 2018, pp. 03–06.
B. Bhavani. Sai, I. Swathi, K. S. L. Prasanna, and K. S. Rao, “design of cooling tower,” vol. 4, no. 5, pp. 1560–1563, 2013.
Ben Costelloe, Donal Finn, “Experimental Energy Performance Of Open Cooling Towers Used Under Low And Variable Approach Conditions For Indirect Evaporative Cooling Of Buildings”, Building Serv. Eng. Res. Technol., vol.24, no.3, pp.163-177, 2003.
D. K. Baniya, A. C. Kurup, and A. Varghese, “Design and Fabrication of Cooling Tower,” International Journal of Latest Engineering Research and Applications (IJLERA) Volume – 02, Issue – 05, , PP – 27-37, May – 2017.
Mohammed Nsaif Abbas, “Study The Performance Of Different Packing In Open Cooling Towers”, Journal Of Engineering And Development, vol. 16, no.2, pp.193-210, June 2012.
P. Ajit, P. Dash, K. K. Panda, A. K. Yadav, and V. Sharma, “Design of mechanical draft cooling tower and determination of thermal efficiency,” IJSDR, Volume 1, Issue, pp. 191–197, April 2016.
M. Rahmati and A. Sedaghat, “Thermal performance of natural draft wet cooling towers under cross-wind conditions based on experimental data and regression analysis,” 6th Conference on Thermal Power Plants, CTPP , Iran University of Science and Technology, pp. 1–5, 2016.
R. K. Singla and R. Das, “Retrieval of Controlling Parameter in Induced Draft Cooling Tower Using Inverse Method, 2nd International Conference on Control Science and Systems Engineering (ICCSSE)” pp. 223–226, 2016.
C. Ionescu, and D. Gogoa, “Improving the Efficiency of Natural Draft Wet Cooling Towers by Using Smart Metering Systems, International Conference on Optimization of Electrical and Electronic Equipment” pp. 134–139, 2017.
S. J. Kulkarni and A. K. Goswami, “Studies and Experimentation on Cooling Towers : A Review,” IJRTS, pp. 279–282, 2015.
K. S. Vishwakarma, A. S. Bhoyar, S. K. Larokar, V. Vaibhav, and S. Bhudhbaware, “Study the factors on which efficiency of cooling tower can be critically acclaimed (A case Study),” vol. 5, no. 4, pp. 73–79, 2015.
J. H. Alsuwaidi, O. R. Al Hamdan, and M. M. I. Hammad, “Natural Draft Cooling Tower Performance Evaluation,” vol. 6, no. 4, pp. 1499–1512, 2015.
N. D. Towers, “Experimental Study of Effects of Cross Wind on Flow in Existing experimental studies, Applied Thermal Engineering” vol. 3, no. 2, pp. 955–958, 1998.
P. H. Margen, B. S. Eng, and A. Member, “the economic selection of cooling towers, IEEE-Part A: Power Engineering pp. 22-26, 1955.
R. Mcelveen, K. Lyles, B. Martin, and W. Wasserman, “A new more reliable solution for cooling tower drives, IEEE Industry Applications Magazine · August 2017” pp. 1–8, 2006.
H. Xie and L. Liu, “Performance Estimation of Cooling Towers Using Adaptive Neuro Fuzzy Inference”, Fourth International Conference on Natural Computation, China, pp. 250–254, 2008.
Downloads
How to Cite
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.